Hi all, just installed ASL3 and using Allmon3. When I connect to a node for the first time it works great but if I disconnect and try to reconnect it says the command was successful but it doesn’t actually connect. I have tried several different nodes with the same results. Also the DTMF codes are not working as well.
July 2, 2024
2:18 PM
brcmfmac: brcmf_sdio_rxfail: abort command, terminate frame, send NAK
kernel
2:18 PM
brcmfmac: brcmf_sdio_read_control: read 1536 control bytes failed: -5
kernel
2:18 PM
mmc1: Controller never released inhibit bit(s).
Scott VA4SMC
10 posts - 2 participants